Home - MEM05 - MEM12006B


Mark off/out (general engineering)

Unit Descriptor This unit covers marking off/out by transferring dimensions from engineering drawings, prints or plans etc. Realted units: This unit is not intended to cover the skills used in a simple transfer of a dimension or marking a location point associated with general engineering and maintenance functions. For these skills see Unit 7.5 (Perform general machining), Unit 18.6 (Repair and fit engineering components) or Unit 18.14 (Manufacture tools, gauges and dies). Where a higher level of calculation, measurement or precision work is required, see Unit 30.12 (Use mathematical techniques and perform simple statistical computations), Unit 12.3 (Perform precision mechanical measurement) or Unit 18.3 (Use tools for precision work) respectively. For marking out structural fabrications and shapes, refer Unit 12.7 (Mark off/out structural fabrications and shapes). This unit covers the marking out skills only. When the manufacture of templates is required, other appropriate units may need to be sel

1 .

Key CompetencyExamples of ApplicationPerformance
How can information be collected, analysed and organised?
How are ideas and information communicated within this competency?
How are activities planned and organised?
How are problem solving skills applied?
How are mathematical ideas and techniques used?
How is use of technology applied?
How is team work used within this competency?

Range Statement

Evidence Guide